The short version of certificate of analysis fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-05-29. Anything still debated is marked as such rather than presented as settled.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
| Property | Value | Notes |
|---|---|---|
| Typical purity report | 95% or higher by HPLC | Area percentage at 214 nm |
| Identity confirmation | Mass spectrometry | Electrospray or MALDI |
| Powder storage | -20 C, desiccated | Protect from light |
| Solution storage | 2-8 C short term | Freeze aliquots for longer |
| Quality document | Certificate of analysis | States method and value |
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Selank is a synthetic heptapeptide developed in Russia. Its sequence is Thr-Lys-Pro-Arg-Pro-Gly-Pro, a seven-residue chain built around the natural tetrapeptide tuftsin. Researchers at the Institute of Molecular Genetics of the Russian Academy of Sciences first described the compound in the mid-1990s. The design combined the tuftsin core with an added Pro-Gly-Pro tail, a modification intended to extend the molecule's stability in biological fluids. Published work on the peptide has appeared mainly in Russian-language journals.
Reported activity for Selank centers on anxiolytic and nootropic effects. Russian clinical reports describe use in anxiety and in cognitive or attention-related complaints. Most of this evidence comes from studies conducted by the same research groups that developed the peptide. Independent replication in other countries remains limited, and no major Western regulatory agency has approved the compound for any indication. The gap between local reports and external verification is a recurring point in discussions of the peptide.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Regulatory status differs sharply by region. Selank holds a Russian marketing authorization, where it is supplied mainly as nasal drops, while authorities elsewhere have not approved it for medical use. Material sold internationally is therefore usually labeled as a research chemical rather than a medicine. Peer-reviewed publications come predominantly from Russian laboratories, and sample sizes are generally small. Whether the compound produces comparable effects under independent, well-controlled replication remains an open question that the broader literature has not settled.
An automated synthesis is very similar in procedure to performing a manual synthesis. The overseeing chemist decides on a target molecule then formulates the experimental plan, which is a sequential series of steps. Then, they collect the required equipment and execute the plan. The automated synthesis follows the same pathway, except that the computer devises and executes the experimental plan. However, human revision is usually still required to ensure the automated route is practical and there are no implicit steps or conditions missing from the proposed procedure. In organic synthesis, organic synthesis software is used to automate the process of identifying sequences of reactions or routes that can be used to synthesize organic compounds.
National teams April 29 – May 1: 2018 FIBA 3x3 Asia Cup in Shenzhen Men: Australia defeated Mongolia, 17–16, in the final. Japan took third place. Women: New Zealand defeated China, 14–11, in the final. Australia took third place. August 5 – 11: 2018 FIBA Under-18 Asian Championship in Thailand In the final, Australia defeated New Zealand, 73–62, to win their 1st title. China took third place. Note: All teams mentioned here, plus Philippines, have qualified to compete at the 2019 FIBA Under-19 Basketball World Cup. October 28 – November 3: 2018 FIBA Under-18 Women's Asian Championship in Bangalore China defeated Japan, 89–76, to win their fifth consecutive and 16th overall FIBA Under-18 Women's Asian Championship title. Australia took third place. Note: All teams mentioned here, plus South Korea, have qualified to compete at the 2019 FIBA Under-19 Women's Basketball World Cup. Clubs teams November 17, 2017 – May 2: 2017–18 ABL season San Miguel Alab Pilipinas defeated Mono Vampire, 3–2 in games played in a 5-legged final, to win their first ABL title. July 17 – 22: Summer Super 8 in Macau Guangzhou Long-Lions defeated Seoul Samsung Thunders, 78–72, to win their first title. Incheon Electroland Elephants took third place.
To meet the NADPH and ATP demands in the mesophyll and bundle sheath, light needs to be harvested and shared between two distinct electron transfer chains. ATP may be produced in the bundle sheath mainly through cyclic electron flow around Photosystem I, or in the mesophyll mainly through linear electron flow, depending on the light available in the bundle sheath or in the mesophyll. The relative requirement of ATP and NADPH in each type of cell will depend on the photosynthetic subtype. The apportioning of excitation energy between the two cell types will influence the availability of ATP and NADPH in the mesophyll and bundle sheath. For instance, green light is not strongly adsorbed by mesophyll cells and can preferentially excite bundle sheath cells, or vice versa for blue light. Because bundle sheaths are surrounded by mesophyll, light harvesting in the mesophyll will reduce the light available to reach bundle sheath cells. Also, the bundle sheath size limits the amount of light that can be harvested.
Sources: en.wikipedia.org
The Tandem Diabetes Care t:Slim X2 was approved by the U.S. Food and Drug Administration in 2019 and is the first insulin pump to be designated as an alternate controller enabled (ACE) insulin pump. ACE insulin pumps allow users to integrate continuous glucose monitors, automated insulin dosing (AID) systems, and other diabetes management devices with the pump to create a personalized diabetes therapy system. Many users of the t:slim X2 integrate the pump with the Dexcom G6, a continuous glucose monitor approved by the FDA in 2018. It was the first CGM authorized for use in an integrated therapy system. The device does not require fingerstick calibrations.
AlphaFold's predicted structures are widely used in biological research, though the precise scale of that use is difficult to measure. More than 40% of protein-structure papers published in 2023 in Cell, Nature, and Science cited AlphaFold 2. A 2024 bibliometric analysis of the Web of Science database identified 1,680 peer-reviewed papers referencing AlphaFold published between January 2019 and May 2024. Measures of this kind rely on authors citing the AlphaFold papers when they use the tool, a convention encouraged but not enforced by the maintainers of the AlphaFold Protein Structure Database. Attempts to validate these counts against the full text of papers suggest that citations to foundational AlphaFold papers can both overstate and understate how widely the tool is used. In an analysis of about 8,900 papers in the PubMed Central Open Access corpus that mentioned AlphaFold, roughly 30% cited none of three foundational AlphaFold papers, while only about half of the papers citing at least one of those three mentioned AlphaFold anywhere in their text. A smaller manual check of 100 papers from a curated protein-literature database found a similar shortfall, with fewer than half of those mentioning AlphaFold including a formal citation.
Water chemistry analyses are carried out to identify and quantify the chemical components and properties of water samples. The type and sensitivity of the analysis depends on the purpose of the analysis and the anticipated use of the water. Chemical water analysis is carried out on water used in industrial processes, on waste-water stream, on rivers and stream, on rainfall and on the sea. In all cases the results of the analysis provides information that can be used to make decisions or to provide re-assurance that conditions are as expected. The analytical parameters selected are chosen to be appropriate for the decision-making process or to establish acceptable normality. Water chemistry analysis is often the groundwork of studies of water quality, pollution, hydrology and geothermal waters. Analytical methods routinely used can detect and measure all the natural elements and their inorganic compounds and a very wide range of organic chemical species using methods such as gas chromatography and mass spectrometry. In water treatment plants producing drinking water and in some industrial processes using products with distinctive taste and odors, specialized organoleptic methods may be used to detect smells at very low concentrations.
Sources: en.wikipedia.org
Purity is usually reported as an HPLC area percentage, most often measured at 214 nm. Identity is confirmed separately by mass spectrometry. A certificate of analysis should state both the method and the observed value.
Dry powder is kept frozen, desiccated, and shielded from light. Dissolved material is aliquoted and frozen to limit freeze-thaw cycles. Short-term refrigerated storage is common for working solutions.
Russia registers it as a prescription nasal product. Most other markets classify it as a research chemical with no approved medical use. Oversight of purity and labeling is consequently minimal in those markets.
Selank is a seven-amino-acid peptide built from the tuftsin sequence plus a Pro-Gly-Pro tail. It is produced by chemical synthesis rather than extracted from a natural source. The free peptide is usually supplied as a lyophilised powder or in an aqueous formulation.